It does show the power of cut and paste... I can even make my songs sound good.
However, this is proof of dangerous sequence when one person or group is allowed absolute power. This is what Ted Cruz is standing up against. I do give him credit for that. This may seem minor, but it is a method of slow manipulation of the many...
On Friday, July 22, just as members of his party were gathering in Philadelphia to coronate Hillary Clinton as their presidential nominee, the Obama Administration once again released a sweeping gun control measure by executive fiat. This time the bad news came via the U.S. State Department’s Directorate of Defense Trade Controls (DDTC), which is primarily responsible for administering the Arms Export Control Act (AECA) and its implementing rules, the International Traffic in Arms Regulations (ITAR). The upshot is that DDTC is labeling commercial gunsmiths as “manufacturers” for performing relatively simple work such as threading a barrel or fabricating a small custom part for an older firearm. Under the AECA, “manufacturers” are required to register with DDTC at significant expense or risk onerous criminal penalties.
Rule by fiat. Even worse when agencies in other areas such as transportation, food, etc, etc,etc... By-pass the rule of law sanctioned by the very rule of law intended to prevent tyranny.
However, this is proof of dangerous sequence when one person or group is allowed absolute power. This is what Ted Cruz is standing up against. I do give him credit for that. This may seem minor, but it is a method of slow manipulation of the many...
On Friday, July 22, just as members of his party were gathering in Philadelphia to coronate Hillary Clinton as their presidential nominee, the Obama Administration once again released a sweeping gun control measure by executive fiat. This time the bad news came via the U.S. State Department’s Directorate of Defense Trade Controls (DDTC), which is primarily responsible for administering the Arms Export Control Act (AECA) and its implementing rules, the International Traffic in Arms Regulations (ITAR). The upshot is that DDTC is labeling commercial gunsmiths as “manufacturers” for performing relatively simple work such as threading a barrel or fabricating a small custom part for an older firearm. Under the AECA, “manufacturers” are required to register with DDTC at significant expense or risk onerous criminal penalties.
Rule by fiat. Even worse when agencies in other areas such as transportation, food, etc, etc,etc... By-pass the rule of law sanctioned by the very rule of law intended to prevent tyranny.
