1) Take a piece of bread, let it mold. White mold bad, green mold good.
2) Scrape off mold into sterile water. (4oz.)
3) Agitate (4oz.) (SHAKE IT!)
4) Filter solution through coffee filter into glass beaker or similar that can stand heat. (4oz.)
5) Heat container in boiling water for 45 minutes, evaporating solution to as close to 1 oz as possible. (may appear milky or clear, either is okay) (less is okay as well)
6) Use sterile cap and shake mixture in order to reclaim all solids in container into mixture.
7) When mixture cools, inject mixture intramuscularly (in muscle) via sterile syringe.
For open wounds, lay moldy bread ON WOUND. (mold side on wound)
For disease, inject intramuscularly (ass cheek preferable or any other large muscle group, NO VEIN!!!)
Note this will save your ass, no pun intended. LOL
2) Scrape off mold into sterile water. (4oz.)
3) Agitate (4oz.) (SHAKE IT!)
4) Filter solution through coffee filter into glass beaker or similar that can stand heat. (4oz.)
5) Heat container in boiling water for 45 minutes, evaporating solution to as close to 1 oz as possible. (may appear milky or clear, either is okay) (less is okay as well)
6) Use sterile cap and shake mixture in order to reclaim all solids in container into mixture.
7) When mixture cools, inject mixture intramuscularly (in muscle) via sterile syringe.
For open wounds, lay moldy bread ON WOUND. (mold side on wound)
For disease, inject intramuscularly (ass cheek preferable or any other large muscle group, NO VEIN!!!)
Note this will save your ass, no pun intended. LOL