Musician Forum - Band Discussion Board - BandMix

I own a rehearsal studios in Chicago and just opened an hourly room with all gear supplied. I am using a Behringer SX2442FX EuroDesk mixer with Behringer powered speakers as mains. If I have a powered stage monitor, what is the proper way to run vocals to the stage monitor for the vocalist?
Thanks.
Joe H.

Identify your monitor sends of which are probably aux 1 thru 4 these are auxillary sends that can be used for monitor sends or effect sends or if your mixer is older it may say monitor out just take that send and run it with a cable to your powered monitor speaker imput (those eurodesks are a 1/4 inch balanced output) then set your e.q. on the corresponding aux controls 1 thru 4. You should have a master Aux volumn section off to the side or top of mixer don't forget to ajust these too. This is very easy good luck!

That's what I thought, but I wasn't sure. I have my first client tonight so I wanted to be sure. Thank you very much for the advice.