Page 1 of 1

WOW, ANOTHER SHOOTING.

PostPosted: Sun Jun 09, 2013 1:45 pm
by ANGELSSHOTGUN
Any one have a good explanation of why suddenly this is becoming daily news.

I don't seem to remember this level of frequency under any other president... except recently under this president.

HMMMM...

We have a closed area here. It's out in Calverton. It was used as government testing area for aircraft. The remains of flight 800 are still there.

Another dumb question... The fence is topped with razor wire. It used to be facing out. The idea is to make it difficult to climb the fence and penetrate from the outside. Recently the wire was all changed around to face the inside. It makes it much harder to exit this way.

I can't figure it out... I guess we must have just had a whole bunch of extra taxpayer dollars and so many underutilized government workers with nothing to do. YA GOTTA KEEP EM BUSY!

Any help here? :wink:

PostPosted: Sun Jun 09, 2013 3:07 pm
by Slacker G
It is a good thing that the media is pushing the ban the gun agenda by searching high and low and exploiting all crimes fire arm related. But they most always leave out the fact that these crimes are not committed by registered law abiding citizens who own legal registered guns within their rights under the 2nd amendment.

The knife, axe, club, poison, vehicle homicides, and the rest are so messy and brutal that I don't care to hear about them.

PostPosted: Mon Jun 10, 2013 12:28 pm
by GuitarMikeB
In a lot of science fiction 'future' stories they call this era the 'crazy years'.
Can't argue with the name.

On the barbed wire thing - maybe they figure if people want to get in, they will (all you have to do is lean a tall ladder against the wire from the outside. Once you're on the inside, its a lot tougher to get out (unless you throw another ladder in when you're are going in).
There's a pet cemetary in town here with barbed wire facing in - now that' s a real 'WTF'! :roll:

PostPosted: Tue Jun 11, 2013 2:56 am
by fisherman bob
Sounds like East and West Berlin all over again...