Hi, I have a Behringer Xenyx 1204 like the one shown below.
My question has to do with the AUX Sends and Returns.
Every channel has a "1 AUX MON-pre" pot, and a "2 FX POST" pot.
But I don't understand what these pots do. Or how they are related to the AUX Sends and Returns jacks pictured above.
To make matters even more confusing there are more Stereo Aux Returns pots above the MAIN MIX section.
What I would like to do is use a guitar amp reverb as the as the FX processor. But I don't know how to wire it up. Or if this can even be done.
So I have several questions.
1. Can I use a small guitar amp as a reverb processor?
2. If so, how do I wire it into the 1204?
3. After I wire it in how do I use the "1 AUX MON-pre" pot, and a "2 FX POST" pot to control the amount of reverb on a channel?
4. Will all channels then have access to this reverb processor?
I have no clue what I'm doing in terms of using an external FX processor.
Thanks for any help regarding these questions.
My question has to do with the AUX Sends and Returns.
Every channel has a "1 AUX MON-pre" pot, and a "2 FX POST" pot.
But I don't understand what these pots do. Or how they are related to the AUX Sends and Returns jacks pictured above.
To make matters even more confusing there are more Stereo Aux Returns pots above the MAIN MIX section.
What I would like to do is use a guitar amp reverb as the as the FX processor. But I don't know how to wire it up. Or if this can even be done.
So I have several questions.
1. Can I use a small guitar amp as a reverb processor?
2. If so, how do I wire it into the 1204?
3. After I wire it in how do I use the "1 AUX MON-pre" pot, and a "2 FX POST" pot to control the amount of reverb on a channel?
4. Will all channels then have access to this reverb processor?
I have no clue what I'm doing in terms of using an external FX processor.
Thanks for any help regarding these questions.